Liquid Detected In Lightning Connector: How to fix it Easily?

Don’t freak out if you plug in your iPhone to charge and see the message “Liquid Detected in Lightning Connector” appear on the screen. This is an exceedingly typical warning message.

An iPhone warning that reads “Liquid Detected in Lightning Connector” indicates that the charging port on your device has been compromised by moisture. You will be able to use your phone normally; however, until the port has completely dried off, you won’t be able to charge it using a lightning cable. However, you can keep your device charged while you wait by using a wireless charger.

What does it imply if the lightning connector has liquid in it?

The charging port on your iPhone is referred to as the “lightning connector.”

Either your phone’s charging port or the lightning charging cable is wet if you get the “Liquid Detected in Lightning Connector” alert.

Liquid Detected In Lightning Connector

Here are some of the most common causes:

  • Leaving your iPhone in the bathroom while you shower might cause a buildup of moisture in the charging port, which can damage your phone.
  • If you’re trapped in a rain storm or even just a light shower, your phone could get soaked.
  • Getting your phone wet in the pool is a certain conclusion.
  • Another surefire way to get your iPhone wet is through a spilt beverage.

Read Also: How to Unforget A Bluetooth device

Do Some Necessary Action

  • When you’re done with your iPhone, set it down on a flat surface and turn it off. If at all feasible, place desiccants around your iPhone to aid with the drying process. Shoe boxes and transport containers sometimes contain little desiccant packets.
  • Then, it’s time to wait for things to work out. Keep your iPhone still for a few minutes. A message on your iPhone may indicate that the connector will require “several hours” to dry.

Read Also: How To Find AirPods Case Within Few Minutes

Avoid To Do Such Activity

  • We’d like to dispel some myths about water damage to iPhones. You’ve probably heard that rice can be used to dry off iPhones that have been submerged in water. Putting your iPhone in rice is a bad idea.
  • A grain of rice could get stuck inside your iPhone because it doesn’t absorb moisture properly. You may make matters worse by submerging your iPhone in rice at this point!
  • In the same way, avoid using a hairdryer or air compressor to dry your iPhone. Either of them could cause more damage to your iPhone by pushing the liquid in the Lightning port even further inside.

What you need to do is as follows:

  • disconnect all the iPhone’s wires and peripherals
  • Gently tap your iPhone’s palm to assist remove any moisture from the Lightning port, then place your phone in an open, ventilated, and dry location for at least 30 minutes before attempting to recharge it again.

What if my iPhone detects liquid even if it’s completely dry

When you’re completely sure that your iPhone and Lightning connectors are dry, you may still get the liquid detection signal.

It’s possible that your phone is fresh new or that you’ve given it ample time to dry out.

Then get a flashlight and check the Lightning port for dust and debris. if this is the case Your iPhone’s liquid sensors can be confused by obstructions in the Lightning port.

Using pressurised air will prevent damage to the metal pins if anything is found.

A damaged Lightning port or the item you’re trying to connect to your iPhone is a high likelihood if you can’t see any debris after flashing a light into the port.

You may need to get in touch with Apple support at this time.

Read Also: Exit Navigation: How to Exit Navigation Step-Wise Process

Get in touch with Apple.

The Apple One-Year Limited Warranty does not cover servicing for liquid damage if your phone was damaged by water.

You can use your phone’s Liquid Contact Indicator to see if this is the case (LCI). After coming into touch with water, the LCI will begin to glow red.

Depending on which iPhone model you have, you’ll see a different LCI position. Thanks to Apple’s efforts, you can now easily find it.

If you’re unsure whether the alert is caused by liquid exposure, you should contact Apple Support.

Read Also: Couldn’t Read Nfc Tag: Check in Smartphones and Other Devices

Conclusion

In order to assist you in gaining a deeper comprehension of the matter, the entire story regarding “Liquid Detected In Lightning Connector: How to fix it Easily? ” has been detailed for you above. Please leave a comment below if you are experiencing any issues with the content, and we will do all in our power to assist you.

Share on:

Hello everyone Iam Aakash Shrivastava a 23 year old web devloper, web designer i have completed engineering and currently working on article writing and making purposefull content. I belongs to sitarganj, it is a small town of one of the indian state uttarakhand. If you have any suggestions regarding my content please leave a comment in my any post i will make sure to reply.

1 thought on “Liquid Detected In Lightning Connector: How to fix it Easily?”

Leave a Comment