The iTel Vision 2 L6503 Flash File now has official stock flash firmware. This firmware will fix any software issues with your iTel Vision 2 L6503, including hang-on logos, fastboot mode, and FRP lock. You may also use it to show blank or white after flashing, uneventful recovery, dead after Flash, and so on.
Table of Contents
About iTel Vision 2 L6503
The Itel Vision 2 phone was released on April 26th, 2021. The display is a 6.60-inch touchscreen with a resolution of 720×1600 pixels and a 20:9 aspect ratio. The Itel Vision 2 is powered by an octa-core processor and has two gigabytes of memory. Its Itel Vision 2 is powered by a strong 4000mAh battery and runs Android 10 (Go Edition).
In terms of cameras, the Itel Vision 2 is the best. The Itel Vision 2 boasts a triple camera setup on the back, with a 13-megapixel primary camera and a 2-megapixel secondary camera. It has a single front camera setup that can be used for selfies, and an autofocus rear camera setup. It has an 8-megapixel camera on board.
Download iTel Vision 2 L6503 Flash File
Device Name: L6503-F6315-10.0-OP-V036-20210519
Type: Full ROM
Size: 6.30 GB
SoC: Qualcomm CPU
|SPD Upgrade tool||34 MB|
|research download tool||10 MB|
|SPD Driver||8 MB|
If Tool is Not Working Than Try This Tool: Transsion Software Download Tool
Read Also: Itel Vision 2 L6503 Frp File (Paid File)
How to Flash iTel Vision 2 L6503:
Install SPD Driver
1. Download the package and Extract Flash Tool.
2. Once you have the icon, Double click SPD Research Tool.exe.
3. It will launch the program on your PC.
4. Click on the load packed button and select the Firmware that has an extension of .pac at the end.
5- Click on the Downloading button located in the third spot.
6. Switch off your mobile phone and connect it to the PC with the volume down button.
7It will guide you to a successful flashing.